First, I loaded the WiFi code onto Arduino and installed the drivers for the Feather Huzzah.
Next, I opened the sketch end edited the variables to account for the PoD Studio WiFi and password. I then uploaded it to the board and got this blinking light.
After, I think I connected the device through WiFI. At some point during this process my LED momentarily lit up. I think this was while the code was loading onto the device. I couldn’t manage to get the LED to turn on by the button though.
Then, I opened serial monitor and watched the readouts it was giving me. I’m not sure what it meant. I think it showed that it was trying to connect to the internet but couldn’t.
Finally, I’ve left the board on and every few seconds it flashes a blue light from the Huzzah itself. I’m not sure what this means.