Hi all!
This weeks challenge was a tough one! It took me a while to figure out what I was doing. The code was uploading fine once my computer found “Leonardo” 😛
However, it seemed that no amount of shaking was going to light up any LED’s on this cardboard. My stitched weren’t the best or tightest however I knew that the connection was strong from last class. It wasn’t until I spoke to some of my classes that I realized the “Thresh-hold” was set too high and that if I dropped it down to a low number it would make the sensor very sensitive. Below are photos and videos of the LED lighting up! 😀 Finally!