Halloween and Neo Pixels

Blue and Green Neo Pixels
Regular Neo Pixel Stick

https://www.tinkercad.com/things/3L75nILlIpN-amazing-waasa-curcan/editel?sharecode=Bmaf8TYtS4-DLtTCi8Br1WbsPIXCuxAshhEIoazAp2U

Below are three of my ideas for Halloween. The first one from the left is simply a wire crown, with a ping ping ball at the center. The ping pong ball would have an LED in the center, and then wires would run to the backside, where there would be a switch. The second idea is a mask with X’s for eyes. This might be a bit tricky, either by sewing two LED strips onto the mesh fabric, or sewing individual LEDs. The mask would be worn more on my forehead than eyes, since I would probably burn my retina if I had X’s over my eyes. The last one is a string of LED’s with plastic bugs glued onto them.

3 Simple Sketches

To make the above props for costumes I would need: wire, thread, rope, needle, LED strips or individual bulbs, ping pong ball, glue gun, batteries, battery holder with switch.

2 thoughts on “Halloween and Neo Pixels”

  1. Hi Jane, thanks for posting up early! Would you mind pasting your custom NeoPixel animation sketch into your Tinkercad code so that we can see how you composed it?

Leave a Reply